Robert Horky
Member
- Messages
- 925
I have wanted to try my hand at one of these for a while. Had some time between projects so gave it a go.
Made from MDF, hardboard, t-track, a few pocket screws, two thumb knobs. The first set of fingers are all 1/2". So, I gave it a try.
Fingers went together with some light mallet taps. A little chip out on one edge, my fault. Forgot to score the edge and pushed the router to hard. Overall, quite pleased for the first try. So, I switched up the fingers ..
Again, went together with some light mallet taps. Good clean cuts. Now, I will make some 5/8", 3/4", 7/8" and 1" fingers. This will give me lots of versatility for the upcoming bedroom set project ... looking to use some Greene and Green style.
Thanks for looking.
Made from MDF, hardboard, t-track, a few pocket screws, two thumb knobs. The first set of fingers are all 1/2". So, I gave it a try.
Fingers went together with some light mallet taps. A little chip out on one edge, my fault. Forgot to score the edge and pushed the router to hard. Overall, quite pleased for the first try. So, I switched up the fingers ..
Again, went together with some light mallet taps. Good clean cuts. Now, I will make some 5/8", 3/4", 7/8" and 1" fingers. This will give me lots of versatility for the upcoming bedroom set project ... looking to use some Greene and Green style.
Thanks for looking.