allen levine
Member
- Messages
- 12,370
- Location
- new york city burbs
I never had a problem learning about diuretics and the ascending loop of Henle, but every after market accessory I purchase, never seems to work or fit right with what I own.
Im waiting a week for the rain and humidity to go away so I can finish the driveway, I decided instead of another day of doing nothing, Ill install the wolverine jig on my grinder.
simple, 6 screws, 1 hour tops, 2 hours tops,
so I discovered the mounting holes on the grinder are in the way of the wolverine jig, seems the base is just too wide and I drill new holes, the base is curved on the top side, so I don't think Ill get a good hole or bolt through straight.
from the pics, you can see the top of the diamond shaped hole on the jig, has to be centered under the wheel.
Even lifting the grinder up, the mounting bolt hole is gone, totally blocked by the inside of the jig.
Im stuck, what can I do?
How can I mount the grinder and set the jig close enough?
maybe theres just some simple solution Im missing, my brain doesn't seem to work great lately.
Im running over to HD to check out other grinders, not to purchase, just to see if between the base and the center of the wheels, theres at least 1.5 inches of space where the wolverine would fit.
Im curious.
Im not ashamed of my lack of knowledge to figure this out. Its frustrating.
Im waiting a week for the rain and humidity to go away so I can finish the driveway, I decided instead of another day of doing nothing, Ill install the wolverine jig on my grinder.
simple, 6 screws, 1 hour tops, 2 hours tops,
so I discovered the mounting holes on the grinder are in the way of the wolverine jig, seems the base is just too wide and I drill new holes, the base is curved on the top side, so I don't think Ill get a good hole or bolt through straight.
from the pics, you can see the top of the diamond shaped hole on the jig, has to be centered under the wheel.
Even lifting the grinder up, the mounting bolt hole is gone, totally blocked by the inside of the jig.
Im stuck, what can I do?
How can I mount the grinder and set the jig close enough?
maybe theres just some simple solution Im missing, my brain doesn't seem to work great lately.
Im running over to HD to check out other grinders, not to purchase, just to see if between the base and the center of the wheels, theres at least 1.5 inches of space where the wolverine would fit.
Im curious.
Im not ashamed of my lack of knowledge to figure this out. Its frustrating.