Robert Horky
Member
- Messages
- 924
Pulled the plug and through one of these together. From the current issue of Shopnotes.
A word of caution if you use these plans. They are based on the new K5 model. If you have an older K3, like I do, the riser height and spacing dimensions will have to be adjusted as needed.
Fun little project and it works well.
Two other notes: the drawer width in the plans is a little shorter than the opening. Too much gap for my liking so I recut and better fit. the drawer height is a little short and will not allow for the portable drill guide holder to be stored in the drawer. I did not catch this one until after the fact so I will have to just clamp it in the K3 during storage.
Thanks for looking.
A word of caution if you use these plans. They are based on the new K5 model. If you have an older K3, like I do, the riser height and spacing dimensions will have to be adjusted as needed.
Fun little project and it works well.
Two other notes: the drawer width in the plans is a little shorter than the opening. Too much gap for my liking so I recut and better fit. the drawer height is a little short and will not allow for the portable drill guide holder to be stored in the drawer. I did not catch this one until after the fact so I will have to just clamp it in the K3 during storage.
Thanks for looking.