Triple veneer pen

Terry Quiram

Member
Messages
212
Location
Roanoke, Illinois
Thanks Mack for suggesting this 3 veneer pen. I like the way this turned out. Curly Maple with Redheart and Maple veneer. This was a little tough wrangling all the pieces for gluing. The Cigar is Cherry with Redheart veneer.
 

Attachments

  • 14120015739701.jpg
    14120015739701.jpg
    78.7 KB · Views: 46
  • 14120017158841.jpg
    14120017158841.jpg
    67.1 KB · Views: 40
Dan it's not hard just labor intensive. Cut your blank lengthwise in a wavey pattern. I use a scroll saw. Glue and clamp in a piece of veneer. I use veneer 1/42 thick. If you use a mild curve it can be a little thicker. Day 2 trim off veneer and glue. Now do it again only this time make sure the curves intersect. Day 3. Clean up veneer and glue. Rotate the blank 90 degrees, cut, glue, clamp. Day 4 repeat day 2.

I just sent 84 blanks to ExoticBlanks.com. They will be available for sale soon.
 

Attachments

  • 14115640259941.jpg
    14115640259941.jpg
    127.9 KB · Views: 17
  • 14115638419041.jpg
    14115638419041.jpg
    81.1 KB · Views: 15
Last edited:
Top