Dave Richards
Member
- Messages
- 2,930
- Location
- SE Minnesota
This showed up in my shop last night.
This saw was in the shop my father and grandfather shared and I made a lot of little boxes and other projects with it. My brother had it for awhile, cleaned it up and painted it black and then loaned to an uncle for a few years. Unfortunately he stored it in a damp garage and the table ended up rusted and pitted. My brother got it back and cleaned up the table best he could and now I've got it.
So I think I'll disassemble it, get black paint of of it and repaint it Delta gray.
Any idea how to remove the rivets holding the little plates on without drilling them and how to get new ones to replace them if needed?
This saw was in the shop my father and grandfather shared and I made a lot of little boxes and other projects with it. My brother had it for awhile, cleaned it up and painted it black and then loaned to an uncle for a few years. Unfortunately he stored it in a damp garage and the table ended up rusted and pitted. My brother got it back and cleaned up the table best he could and now I've got it.
So I think I'll disassemble it, get black paint of of it and repaint it Delta gray.
Any idea how to remove the rivets holding the little plates on without drilling them and how to get new ones to replace them if needed?