Sheild Template

Leo Voisine

Member
Messages
5,703
Location
East Freeetown, Massachusetts
Last year I made 2 Route 66 Wall Plaques. It does not show in the picture but they are domed with raised letters.

As a result - the scrap pieces would make beautiful templates. You would need to use a 1/4 inch template bit in a hand held router, and you would end up with the same shape as the Route 66 plaque.

They will need a little EASY file and sandpaper cleanup.

The wall plaque is 18 inches.

The outside square of the template is 24" square, and the template is 3/4 thick.

If nobody wants it - I will cut it up and burn it.

PRICE = you pay shipping only.

I have 2 available

sheild-1.jpgshield-2.jpgshield-3.JPG
 
A very cool offer Leo. I hope someone takes you up on it. This could also be used for a bowl template with a 3/4" bowl bit with decent success.
 
Top