Dan Mooney
Member
- Messages
- 1,920
- Location
- Portland, Oregon
Hey Jason,
I've been watching your videos on the guitar build and found the videos on making the fret sawing rig. The question I have is: I have the same Grizzly metal lathe, but mine doesn't have the same tool post.
Can you give some info on the changes you made. I've found the cutters available (5/16") for the stock tool post very limited and the quality poor.
Appreciate any info.
Dan
I've been watching your videos on the guitar build and found the videos on making the fret sawing rig. The question I have is: I have the same Grizzly metal lathe, but mine doesn't have the same tool post.
Can you give some info on the changes you made. I've found the cutters available (5/16") for the stock tool post very limited and the quality poor.
Appreciate any info.
Dan