larry merlau
Member
- Messages
- 18,741
- Location
- Delton, Michigan
i am in the middle of a hutch with 3/8" solide panels, well when cross cuttin one of the long panels after they had been sanded to thickness and ready to go insde, one end of the glue joint let loose i had seen a line but thoiught it was just a dark line not it looks like it let loose for about 3 inches. i have 1/16 for movemnt on this panel its only 10 3/4" wide what should i do can i put some ca glue in there on the end and have hold? this will be clear lacquer finish... after that i quit for the night checked the other off cuts and they seem fine. its gonna be at the top and i have 3/8 groove for it to set in if i glue the panel in the center of the grove or pin it will that hold it from going bad?
thanks for your help.
thanks for your help.