Mike Turner
Member
- Messages
- 361
- Location
- Laurinburg NC
I am in beginning stage of making this bowl sanding hood.Mine will be longer as I will sand my flutes in it in which a few are 34" long.I will have a 4" hose from my HF dust collector going to it but I dont know what kind of vent to buy or make.I know it have to be longer than usual.I hope the HF dc can pull enough.I may have to do some creative when I do the long 34" flute.Dont do many that long but maybe I can slide a divider in there or something to close off part of the hood if it isnt pulling enough with all of the hood "open"....not concerned about the 34" as much but the most common size I do is 30"....Any ideas on the vent are welcomed! Thanks in advance!