- Messages
- 16,585
- Location
- Reno NV
I'm hoping I can get a reply to this question without a whole lot of smart aleck comments.
If you had a table top and a base that met like this, how would you attach the two?
My thought is to put a threaded insert into the table top, and a recessed slot on the support with a bolt and washer going through the support to allow for side to side wood movement.
Thanks in advance for your serious replies and help.
If you had a table top and a base that met like this, how would you attach the two?
My thought is to put a threaded insert into the table top, and a recessed slot on the support with a bolt and washer going through the support to allow for side to side wood movement.
Thanks in advance for your serious replies and help.