NOT for the Swap!

Brent Dowell

Administrator
Staff member
Messages
16,540
Location
Reno NV
So, I've built a bunch cutting boards but never have really made one for myself. I've got what I consider to be the factory rejects.

This is no exception. When I was putting together the strips I had an Idea of how it would work, with 2 different sized blocks. I would offset them and then when I flipped it over they would all line up with the joints not intersecting. Note to self, Next time try it in sketchup first!

Oh well, So I put it together any way and just slightly offset the joints. Not as strong as it could be, but I'm not going to have any dancing girls prance around on it.

It should be good enough for Guvmint work. Lasered it up too. Why not.

20151001_181117.jpg
 
Top