Keith Krueger
Member
- Messages
- 53
Dave: I have been trying some of your posts on sketchup and have some questions about how the intersect works with groups/components?
In the mitre cut demo if the part being cut at 45 was not a group or component then I got the intersect to work and could delete the necessary details to show mitered cut.
If the part was already a group or component then nothing seemd to happen. How does intersect work on groups or components.
For example the raised panel door demo you used intersect with model to create the cope cuts and size the rails and these parts were components. When I tried this nothing seems to happen.
In the mitre cut demo if the part being cut at 45 was not a group or component then I got the intersect to work and could delete the necessary details to show mitered cut.
If the part was already a group or component then nothing seemd to happen. How does intersect work on groups or components.
For example the raised panel door demo you used intersect with model to create the cope cuts and size the rails and these parts were components. When I tried this nothing seems to happen.