- Messages
- 20,168
- Location
- Springfield, Missouri
Any one tried doing one of these yet in vcarve? I'm planning to give it a try tomorrow if I have time. Below are two tutorials I've found on doing them.
http://www.vectric.com/support/training-material/bonus/vinlay.html
http://www.vectric.org/video/aspire...07/VCarve_Inlay_Description_and_Procedure.pdf
Attached is one of my samples I'm planning to run.
View attachment maple_leaf.crv
http://www.vectric.com/support/training-material/bonus/vinlay.html
http://www.vectric.org/video/aspire...07/VCarve_Inlay_Description_and_Procedure.pdf
Attached is one of my samples I'm planning to run.
View attachment maple_leaf.crv