Paul Douglass
Member
- Messages
- 4,995
- Location
- S E Washington State
Have a question. I have a Steel City uni-type table saw. Very similar to a Delta, the people that started Steel City tools were ex-Delta people.
The blade on the saw is slowly creeping to the right. As you can see in the picture below, this was a zero clearance insert. Over time a gap has formed to the left of the blade. Something appears to be moving. Or am I nuts??
Notice the white arrows pointing on the insert. This is happening on my other inserts also.
The blade on the saw is slowly creeping to the right. As you can see in the picture below, this was a zero clearance insert. Over time a gap has formed to the left of the blade. Something appears to be moving. Or am I nuts??
Notice the white arrows pointing on the insert. This is happening on my other inserts also.
Last edited: