Toni Ciuraneta
Member
- Messages
- 5,629
- Location
- Catalunya
Hi guys.
Seems that pressure is diminishing and that I have a bit more time to ww and to log on. So I set up this moring to fine tune my jointer/thicknesser.
THe jointer part is easy and after a few adjustments I got it right. But I had detected some time ago that the thicknesser needed adjustment as well as I cannot get parallel surfaces on it.
This is my jointer/thicknesser:
At the beginning I thought that these small headless bolts were to adjust the bed but they are only to lock the nuts that carry the bed up and down. Unless it has to be adjusted from below or that the chains that hook onto the pinions have got some slack I can't find both the cause of the misalignement or the way to fix it.
On the owner's manual there is no mention at all about it and on youtube I have only found the way to adjust the blades on the jointer, not the thicknesser bed, so if any of you have any clue I would appeciate any help that you can get me.
I include the exploded view of the manual in case it helps.
Many thanks in advance.
Seems that pressure is diminishing and that I have a bit more time to ww and to log on. So I set up this moring to fine tune my jointer/thicknesser.
THe jointer part is easy and after a few adjustments I got it right. But I had detected some time ago that the thicknesser needed adjustment as well as I cannot get parallel surfaces on it.
This is my jointer/thicknesser:
At the beginning I thought that these small headless bolts were to adjust the bed but they are only to lock the nuts that carry the bed up and down. Unless it has to be adjusted from below or that the chains that hook onto the pinions have got some slack I can't find both the cause of the misalignement or the way to fix it.
On the owner's manual there is no mention at all about it and on youtube I have only found the way to adjust the blades on the jointer, not the thicknesser bed, so if any of you have any clue I would appeciate any help that you can get me.
I include the exploded view of the manual in case it helps.
Many thanks in advance.
Last edited: