Dave Black
Member
- Messages
- 638
- Location
- Central PA
Several years ago I built a Pentz cyclone and blower. Well I'm going over my setup and I'm changing some stuff around and I see that my blower housing is not to the correct size. I believe that when I built it it was correct to the plans listed but now it seems that there was a redo of the info on bills site about the blower. I have a 15" impeller but the plans are for a 14" and 16". It says that for a 15" just print out at 107% scale. I'm having problems getting that to work on windows 10 or OS X. I also don't know if it's scaling correct because I don't have any dimensions to go off. Ideas. I thought about just multiplying the 14" dimensions x 1.07 but it would be much easier to print it off.
http://billpentz.com//woodworking/cyclone/blower.cfm
http://billpentz.com//woodworking/cyclone/blower.cfm