Menu
What's new

soup stirrer mk 3

Dan Noren

Dan Noren

Moderator
Staff member
Messages
7,986
Location
falcon heights, minnesota
here we go again! another of the church ladies who cook large amounts of soup asked if i would make one for her too. with a bit of white oak that cost $2, we're off to the races. only thing done with this was to plane it smooth. tomorrow i'll set up a new template for this one.
 

Attachments

  • 001 board planed smooth.jpg
    001 board planed smooth.jpg
    93.2 KB · Views: 16
all but finished this one off today. laid out the lines from the template on sunday, then today i did the rough cutting, sanding to lines, drilled the hanger hole, and rounded over all the edges. now all that is left is to give it a good sanding, oiling, and the hanger strap.
 

Attachments

  • 002 rough cut.jpg
    002 rough cut.jpg
    122.9 KB · Views: 18
  • 003 sanded to the lines.jpg
    003 sanded to the lines.jpg
    112.7 KB · Views: 17
  • 004 hanger hole cut.jpg
    004 hanger hole cut.jpg
    121.2 KB · Views: 16
  • 005 hanger hole edges rounded over.jpg
    005 hanger hole edges rounded over.jpg
    103.7 KB · Views: 19
  • 006 all edges rounded over.jpg
    006 all edges rounded over.jpg
    122.6 KB · Views: 19
You must log in or register to reply here.
Top