- Messages
- 7,984
- Location
- falcon heights, minnesota
with things going so good today, i decided to attempt to do the juice grooves in a couple of boards for my brother's gf's daughter. first i rounded over the edges (as long as the bit was in the router). then i measured and cut the blanks for the templates. then drilled the holes for a rounded corner. then using the very good tape in the picture, attached the templates to the boards, then the boards to the bench i was using. then i started to route the grooves along the template edges. all went well until the last cut. the one for the larger of the 2 boards went ok, but the smaller one got away from me. only way to save the smaller board will be to plane it down, and call it a bread board.
Attachments
-
001 ready for grooving.jpg103.6 KB · Views: 47
-
010 ready to start grooves.jpg119.3 KB · Views: 53
-
009 board hold downs.jpg96.3 KB · Views: 53
-
008 templates attached.jpg97.5 KB · Views: 50
-
007 templates ready to attach.jpg101.9 KB · Views: 50
-
006 good tape.jpg90.3 KB · Views: 50
-
005 both templates cut.jpg96.6 KB · Views: 50
-
004 holes cut for corners.jpg95.5 KB · Views: 49
-
003 template blanks cut.jpg95.6 KB · Views: 47
-
002 edges rounded over.jpg97.2 KB · Views: 46