Rail and Stile profile cutting

Matt. Do you have any fluting bits? 1/4" straight, round bottom
 
or you could

just buy the bits set for your self and do the work quicker and you keep the bits and they get the door frames,, you both win and maybe they would cough up half of the bit set just to get it done quicker. they could put you to better use elswhere.
 
Go old fashioned, make a real tenon rather than a stub and just miter or cope the profiles at the intersection. Door would last longer that way anyhow.
 
Matt, I can't tell from the pic that you've provided...is the profile "round" like Steve's example of the 6001 bit set? Or is it more like this profile:

111bit set.jpg

If not, would this bit set with this profile work?
 
Well, DANG then!!! I had the set that I pictured above that I was going to send you. Sorry it won't work for you.


Hope you get it worked out.
 
Hey Matt,
Tell the boss you will get the bits now and he can buy them from you in July. :thumb:

DT
 
Top