Rob Keeble
Member
- Messages
- 12,633
- Location
- GTA Ontario Canada
Just wondering, does anyone here use an 8 1/4" inch blade in a 10 inch table saw.
I know some folks use a 6 inch dado as opposed to 8 1/4" inch dado given how deep most dado cuts are.
I have spotted an opportunity to purchase 8 1/4" inch freud thin kerf blades for ridiculously low price in 40 tooth finishing blade tooth format at around $13 US or $16.75 Cdn.
I figure for most cutting this will provide more than enough blade height.
By my figuring i would only be loosing 1 inch.
Whats wisdom here say.?
These blades are less than half the price of 10" same manufacturer same kerf.
I know some folks use a 6 inch dado as opposed to 8 1/4" inch dado given how deep most dado cuts are.
I have spotted an opportunity to purchase 8 1/4" inch freud thin kerf blades for ridiculously low price in 40 tooth finishing blade tooth format at around $13 US or $16.75 Cdn.
I figure for most cutting this will provide more than enough blade height.
By my figuring i would only be loosing 1 inch.
Whats wisdom here say.?
These blades are less than half the price of 10" same manufacturer same kerf.