Jeff Horton
Member
- Messages
- 4,272
- Location
- The Heart of Dixie
I have several projects in the works that will use frame and panel construction. Arts and craft style so square corners, no ogee edges. I have made these in the past just using the table saw and a dado blade. It works but what I hate is when you have to go back and make one piece you forgot. Set up can take so long for one piece.
Thought I would look at other options and see what suggestions you guys had.
One thing on my list is using the shaper. I have one in my shop I need to restore. Mechanically I think it's pretty good. Cosmetics is another story! But I could restore it in a couple of weeks of hard work. I am thinking it might be the ideal machine for this project.Pretty simple to set up and adjust and I don't have to break it down once I get it set up.
Any other suggestions?
Thought I would look at other options and see what suggestions you guys had.
One thing on my list is using the shaper. I have one in my shop I need to restore. Mechanically I think it's pretty good. Cosmetics is another story! But I could restore it in a couple of weeks of hard work. I am thinking it might be the ideal machine for this project.Pretty simple to set up and adjust and I don't have to break it down once I get it set up.
Any other suggestions?
Last edited: