- Messages
- 20,089
- Location
- Springfield, Missouri
Looking through youtube I came across a video on doing lithophanes on the 3d printer using Cura, I later found another that uses an online site for creating them (free) which seemed to work a little better and had options for creating them in shapes (curves, cylinders, etc)
https://www.youtube.com/watch?v=feL0OMZwZoo
Using http://3dp.rocks/lithophane/
https://www.youtube.com/watch?v=WP1ejhk7XGk
Here are some samples of what I'm planning to try:
I ordered some pearl while filament, the slicer says it will take about 2 1/2 hours for a roughly 3" x 4" pane. It's close to 5 1/2 hours for a 5" x 7", so starting small.
https://www.youtube.com/watch?v=feL0OMZwZoo
Using http://3dp.rocks/lithophane/
https://www.youtube.com/watch?v=WP1ejhk7XGk
Here are some samples of what I'm planning to try:
I ordered some pearl while filament, the slicer says it will take about 2 1/2 hours for a roughly 3" x 4" pane. It's close to 5 1/2 hours for a 5" x 7", so starting small.
Last edited: