Mike Turner
Member
- Messages
- 361
- Location
- Laurinburg NC
I am a flutemaker and I am experimenting some with a new type of flute...new to me that is.Anyhow I need to make a jig where I can hold a flute which would be a 1 1/2" square by 30" or so inches. I may at some point decide to turn the flute on the lathe to its shape and then cut a groove about 2" or so long in the top.I need to be able to look really good at what I am doing so putting it on a regular router table won't work for me.It would be good if I have the router on top and can look down sort of from the side at what I am cutting. Basically like a milling machine.Thanks for any ideas!!