- Messages
- 8,633
- Location
- Thomasville, GA
It looks like auto-leveling is working on my A8 now that I got the firmware updated, etc. A couple of questions:
The default leveling in Skynet is LINEAR but some think BILINEAR is better. What say you?
//#define AUTO_BED_LEVELING_3POINT
#define AUTO_BED_LEVELING_LINEAR
//#define AUTO_BED_LEVELING_BILINEAR
To adjust the offset between the auto-level reading and the actual position of the hot end, is G92 the correct command? How much offset do you use?
Thanks!
The default leveling in Skynet is LINEAR but some think BILINEAR is better. What say you?
//#define AUTO_BED_LEVELING_3POINT
#define AUTO_BED_LEVELING_LINEAR
//#define AUTO_BED_LEVELING_BILINEAR
To adjust the offset between the auto-level reading and the actual position of the hot end, is G92 the correct command? How much offset do you use?
Thanks!