- Messages
- 8,633
- Location
- Thomasville, GA
I may have asked this before, but I lost some bookmarks.
What 3d printer forum do you find to be the best?
Thanks!
What 3d printer forum do you find to be the best?
Thanks!
Seems like I'm doing about the same things.
If I recall properly, both of you guys are using Skynet3d firmware. What version are you on?
Amazing there's not one super site for 3D printing. I've been following your discussions here and watching what you guys build and it's been very interesting. The little bit of knowledge I picked up here helped me last week to design (SketchUp), export (.stl) and print some 3D graphics on my grandson's XYZ da Vinci 1.0 printer to help someone restoring a vintage car battery for a big time car collector. All the various setting combinations were very puzzling and I spent a lot of time thrashing around various forums looking for ways to make the lettering better. Fortunately, my grandson and his Dad were able to figure it all out and get the piece finished for today's judging. The whole process was very interesting....another rabbit hole to fall down!
Looks like version 2.3.1, probably should look to see if there is a more recent one, but things have been working pretty well on mine, so didn't want to mess it up. ...
Yeah, it is definitely a rabbit hole, but once you get some of it down, it's pretty straight forward. Then again, same as with my firmware version, I really got to the point I was able to do what I was wanting to do and kinda stopped trying to improve.