Dave Hawksford
Member
- Messages
- 7,707
- Location
- Outside the beltway
Cutting jig
- Thread starter Dave Hawksford
- Start date
- Messages
- 11,632
- Location
- Constantine, MI
Pros - Easy set up, repeatable, low cost
Cons - could ruin your blade if misaligned.
Charlie Plesums
Member
- Messages
- 1,523
- Location
- Austin, Texas
I often use the old fashioned twin screw wood clamps for cuts near a blade or router bit. A few of the do have scars. The cheap ones from Harbor Freight are adequate for this use.