Rob Keeble
Member
- Messages
- 12,633
- Location
- GTA Ontario Canada
Hi All i am looking to put a keyless chuck on my grizzly 20 inch drill press. (http://www.grizzly.com/products/12-Speed-20-Floor-Drill-Press/G7948)
The chuck on there is a J3 and its fitted to a Mt4 taper .
Have any of you got a recommendation for me to look at for a starting point in procuring a new chuck.
I have no clue except to know i want a chuck that will hold smaller drills better than the one on there and hopefully run true.
Open to being schooled thanks for any help and guidance you may offer.
The chuck on there is a J3 and its fitted to a Mt4 taper .
Have any of you got a recommendation for me to look at for a starting point in procuring a new chuck.
I have no clue except to know i want a chuck that will hold smaller drills better than the one on there and hopefully run true.
Open to being schooled thanks for any help and guidance you may offer.