Stuart Ablett
Member
- Messages
- 15,917
- Location
- Tokyo Japan
OK, I'm looking for a motor for the Bandsaw, I'm going to end up going with a 3-phase unit mostly due to price, and the fact I have 3-phase, so why not?
Anyhow, I found this one motor, and I was reading the nameplate.............
This is a 4 pole motor, right?
Now it has two speeds listed for each Hz level....?
At the 50 Hz 200V 4 pole set up, the rpms of the motor are listed as the typical 1415 range, but it has a 2 pole set up as well, and lists the rpms as 2750........
You see, one of the basic problems with my cyclone is that motor that came with the blower spins too slow for the best suction. A faster spinning motor would be great, but I've really had a hard time finding one.
If I get this motor and swap it out with the one on the cyclone, then I'll have that one for the bandsaw 2.2 Kw ( about 3 Hp ).
Would there be any downside to this idea?
Cheers!
Anyhow, I found this one motor, and I was reading the nameplate.............
This is a 4 pole motor, right?
Now it has two speeds listed for each Hz level....?
At the 50 Hz 200V 4 pole set up, the rpms of the motor are listed as the typical 1415 range, but it has a 2 pole set up as well, and lists the rpms as 2750........
You see, one of the basic problems with my cyclone is that motor that came with the blower spins too slow for the best suction. A faster spinning motor would be great, but I've really had a hard time finding one.
If I get this motor and swap it out with the one on the cyclone, then I'll have that one for the bandsaw 2.2 Kw ( about 3 Hp ).
Would there be any downside to this idea?
Cheers!