Doug Shepard
In Memorium
- Messages
- 772
- Location
- Waterford, MI
My bad.
Here's the pics of the mongrel gates.
Here's the pics of the mongrel gates.
DC duct routing question
- Thread starter Doug Shepard
- Start date
Doug Shepard
In Memorium
- Messages
- 772
- Location
- Waterford, MI
Just an update on the "remote" ( 
) gates. 3 of my 4 gates are now installed and this appears to be working out rather nicely. I can reach these from below and they're working smoothly. I've got all my above the rafter stuff done now. Just need to take care of the downtube stuff, flex hose, and machine hookups. I can see light at the end of the tunnel.
I'm using 2 keyrings on the pull chain. One at the end of the chain for a finger pull and the 2nd located to slip over a steel pin into a 2x4 plate screwed to the bottom of the rafters.
With the chain hanging free, the gate is in the open position.
Pulled down and slipped over the pin, the gate is now closed.
) gates. 3 of my 4 gates are now installed and this appears to be working out rather nicely. I can reach these from below and they're working smoothly. I've got all my above the rafter stuff done now. Just need to take care of the downtube stuff, flex hose, and machine hookups. I can see light at the end of the tunnel. I'm using 2 keyrings on the pull chain. One at the end of the chain for a finger pull and the 2nd located to slip over a steel pin into a 2x4 plate screwed to the bottom of the rafters.
With the chain hanging free, the gate is in the open position.
Pulled down and slipped over the pin, the gate is now closed.