Sean Wright
Member
- Messages
- 902
- Location
- WNY, Buffalo Area
I've recently finished some jigs and small shop items, and I figured I should post the pictures..... 'cause without a picture.... it didn't happen.
First was a push block for the TS.
Next I had slightly revised the Rail Coping Jig, and swapped some MDF for Birch Ply, to give the screws something to bite into.
Next, I made my 1st Zero Clearance Inserts for my table saw. I have also included a picture of what my shop made splitter looks like.
Finally, In anticipation of my Steel City DC (hopefully will pick it up tomorrow ) I made the "poor man's cyclone", a shop built trash can separator. I know I could have bought one, but it was fun making my own.
First was a push block for the TS.
Next I had slightly revised the Rail Coping Jig, and swapped some MDF for Birch Ply, to give the screws something to bite into.
Next, I made my 1st Zero Clearance Inserts for my table saw. I have also included a picture of what my shop made splitter looks like.
Finally, In anticipation of my Steel City DC (hopefully will pick it up tomorrow ) I made the "poor man's cyclone", a shop built trash can separator. I know I could have bought one, but it was fun making my own.