Bart Leetch
Member
- Messages
- 3,206
My old 78 F250 & I shook rattled & rolled 185 miles to my Dad's & back I left last Wednesday & came back Sunday with the Craftsman 100 series 10" Table-saw, C-Man Jointer Dad purchased about the same time frame, 10" C-Man RAS from the early 60's & a air compressor + a few boxes of misc. tools & a whole set of dishes. The next trip I will bring the Bellsaw planer & 2 shapers home & ????? what ever else Dad can figure out to shove into my truck.
My old F250 6 cylinder didn't miss a beat. When I got ready to leave & hit the gas peddle twice & then turned the motor over it just turned over & started Dad's eye brows went up & he said not bad. I told him it wasn't like this when I got it.
We are going through the belongings from 2 lives my Dad's & Step moms 50+ years worth of both lives & getting things down to where everything will fit into a 1188 sq. ft. manufactured home.
I'll be going down again on Wednesday.
My old F250 6 cylinder didn't miss a beat. When I got ready to leave & hit the gas peddle twice & then turned the motor over it just turned over & started Dad's eye brows went up & he said not bad. I told him it wasn't like this when I got it.
We are going through the belongings from 2 lives my Dad's & Step moms 50+ years worth of both lives & getting things down to where everything will fit into a 1188 sq. ft. manufactured home.
I'll be going down again on Wednesday.