Thanks tod. Am I correct in that you dado the slot in the length of a rail and then glue the Two rail halves together. Then drill the holes in the stiles to fit the althred through? This is, as i understand it, a rail that is made up os glued up pieces.
Question 2.
What type of shaper knives or head do you use to make the groves for your panels and could you mod it for glass panels so if broken they could be taken out and replaced.
I remembered the thread and liked it a lot, very smart, but couldn't remember where it was.
My doors will be made from eighter ash or white oak. All the door frameing will be built in the shop, no pre-hung stuff. I want to make it all like they are original but useing your method of putting the doors together so they won't come apart
Reg
P.S I would do a screen shot but dont have that type of program