Sean Wright
Member
- Messages
- 902
- Location
- WNY, Buffalo Area
Its been over a week since I finished my last shop project, the downdraft box. I know I said that I was going to actually make something non-shop related next time........ But I'm getting the urge to make a Drill Press Table.
I was thinking of doing something along the lines of the commercially available one pictured below. I have a Delta 12in DP similar to the one pictured (with the sanding drum), but with lasers.
Has anyone made one? If so I'd like to see a picture or two if you don't mind.
Also if anyone has any recomdenations on what works or doesn't work on either one you made or one you bought, that would be great too.
Thanks!
I was thinking of doing something along the lines of the commercially available one pictured below. I have a Delta 12in DP similar to the one pictured (with the sanding drum), but with lasers.
Has anyone made one? If so I'd like to see a picture or two if you don't mind.
Also if anyone has any recomdenations on what works or doesn't work on either one you made or one you bought, that would be great too.
Thanks!