Sean Wright
Member
- Messages
- 902
- Location
- WNY, Buffalo Area
My understanding of Drill Press sizes was that you take the inch size (12in, 16in etc...) and divide it by 2. This is will be the distance between the post and the center of the chuck/drill bit. With a 16in DP you could drill into the center of a 16in wide piece of stock (hole at 8in). I have a Delta 12in bench top model and it is 6in from the post to the center of the chuck.....I just measured after reading the information below. http://www.deltaportercable.com/Products/ProductDetail.aspx?ProductID=15000#imgAnchor
I receive the free Woodworker's Jounal eZine. I was looking through it and saw the following question and answer on drill press size, and it baffeled me.
Was my original understanding correct, and they are wrong? Or am I wrong and Delta mis-printed my 12in DP, as it should be a 6in DP?
I'm pretty sure I'm right (like 99.5%), but they are the magazine people, so......
I receive the free Woodworker's Jounal eZine. I was looking through it and saw the following question and answer on drill press size, and it baffeled me.
Was my original understanding correct, and they are wrong? Or am I wrong and Delta mis-printed my 12in DP, as it should be a 6in DP?
I'm pretty sure I'm right (like 99.5%), but they are the magazine people, so......
http://www.woodworkersjournal.com/ezine/qanda.cfm#3Q: The advertisements for drill presses say 10-inch,12-inch, 15-inch and so on. To what does that measurement refer?
Andy Rae: Like a band saw, the measurement refers to the distance from the business end of the tool — in your case, the centerline of the quill, chuck, or drill bit — to the post. For example, on a 12-inch drill press, you should be able to drill into the middle of a 24-inch wide panel. Be advised that the manufacturer’s stated size is nominal; your actual drilling capacity may vary by an inch or so.
Richard Jones: The distance between the pillar and the centre of the chuck.