Mark Rios
Member
- Messages
- 797
- Location
- Central CA
The aluminum is 3/16" thick. It's an extruded aluminum sub-fence so in a couple of places it is thicker. I need to make a rip approximately 16" long.
Is there anything special that I need to do to cut this on my Uni?
Or should I clamp it down and try to cut it straight with my jigsaw?
I wouldn't have worried too much about it on my old Ridgid but I don't want to do something wrong with or to this saw.
Thanks very much for yor advice.
Is there anything special that I need to do to cut this on my Uni?
Or should I clamp it down and try to cut it straight with my jigsaw?
I wouldn't have worried too much about it on my old Ridgid but I don't want to do something wrong with or to this saw.
Thanks very much for yor advice.