Well, it is with some trepidation that I post this, considering all the wonderful stuff I've seen here, but I've got to start some where.
In August LOML and I packed the car and started roaming, got to Atlanta as mentioned in this thread
http://familywoodworking.org/forums/showthread.php?t=4998
Took a one day turning workshop. Here is the result, time didn't allow me to finish sand or finish, (as you can see from some of the tooling marks -- I don't even remember if I got to use a scraper on it) so now I guess I've got some handwork in front of me.
I do have a spinny thing on order, not here yet and I am sure it will take a bit to get it set up. Don't know how I'm going to be able to attach this (jam chuck for outside?) but how do I finish the inside?
I think its maple, 7" dia, 1 5/8 deep
Thoughts, comments, criticism and guidance deeply appreciated!
Jay
In August LOML and I packed the car and started roaming, got to Atlanta as mentioned in this thread
http://familywoodworking.org/forums/showthread.php?t=4998
Took a one day turning workshop. Here is the result, time didn't allow me to finish sand or finish, (as you can see from some of the tooling marks -- I don't even remember if I got to use a scraper on it) so now I guess I've got some handwork in front of me.
I do have a spinny thing on order, not here yet and I am sure it will take a bit to get it set up. Don't know how I'm going to be able to attach this (jam chuck for outside?) but how do I finish the inside?
I think its maple, 7" dia, 1 5/8 deep
Thoughts, comments, criticism and guidance deeply appreciated!
Jay
Last edited: