- Messages
- 36,130
- Location
- ABQ NM
This barely qualifies as flatwork, but at least I did use the table saw and router table. And I actually had to measure stuff. Oh, the horrors!
The sign was done by Pete Simmons (discussed in this thread), and I finally cleared off the table saw so I could make some cherry molding for a frame.
It's nice to know that after quite a while of being used as a finishing table (with an appropriate cover)for bowls and hollow forms, the ol' saw can still cut a decent miter.
Thanks again to Pete for the great sign...it'll get a test run next weekend.
The sign was done by Pete Simmons (discussed in this thread), and I finally cleared off the table saw so I could make some cherry molding for a frame.
It's nice to know that after quite a while of being used as a finishing table (with an appropriate cover)for bowls and hollow forms, the ol' saw can still cut a decent miter.
Thanks again to Pete for the great sign...it'll get a test run next weekend.