Niki Avrahami
In Memoriam
- Messages
- 267
- Location
- Poland
Good day
I made as an aid to hold the Outfeed side pressed to the fence but later I made it with two wheels, one before and one after the blade.
Again, the wheel is inclined toward the fence and when the workpiece is passing, the wheel presses it to the fence.
I set the wheels height to about 5/32"~1/4" below the board height by changing the spacers.
Regards
niki
I made as an aid to hold the Outfeed side pressed to the fence but later I made it with two wheels, one before and one after the blade.
Again, the wheel is inclined toward the fence and when the workpiece is passing, the wheel presses it to the fence.
I set the wheels height to about 5/32"~1/4" below the board height by changing the spacers.
Regards
niki