Bill Simpson
Member
- Messages
- 1,756
Not a big deal and I assume that many of you already know of the handiness of the Flushcut or Japanese Pull Saw. Well I am an old diehard, dyed in the wool (so to speak) kind of guy. If it ain't broke, don't try to fix it. So I never ventured into the realm of this "new" saw.
Lately I have been doing some modifications on a reproduction of a Model T Towncar, all wood body. A local fellow had a another guy build him this Repro. After he got it, he was not satisfied as he felt it was not accurate in design with the original. So, here I come to the rescue. Been taking off pieces and reshaping and re-installing and trying to stay within the tight demands of this fellow. Anyway, back to the Primus, I ran into places where my standard saws could not reach or left such a kerf that repairs were severe. Off to the "Store" and looked at several, being the cheap rascal I am, I selected an inexpensive version, not knowing if I would like the concept.
I am here to tell you that that little gem is as handy as the pockets full of dust on my shirt. Makes such smooth thin line cuts, reaches in under joints and releases them. I am applying some thin Hard Maple molding trim pieces tonight and the ability to cut a precise angle and thin cut is just great. Had to cut previously installed molding and make it fit the new, w/o leaving a scar on the surrounding wood. Yes I have taken a gazillion pictures and will post some as it comes together.
If you are like me and procrastonated as long as I, then I urge you to try this handy tool. If the expensive saw are any better than this cheap one, then I'm investing my beans on a new one.
I wont say that it is a better concept but for certain applications it is the "Berries"
Lately I have been doing some modifications on a reproduction of a Model T Towncar, all wood body. A local fellow had a another guy build him this Repro. After he got it, he was not satisfied as he felt it was not accurate in design with the original. So, here I come to the rescue. Been taking off pieces and reshaping and re-installing and trying to stay within the tight demands of this fellow. Anyway, back to the Primus, I ran into places where my standard saws could not reach or left such a kerf that repairs were severe. Off to the "Store" and looked at several, being the cheap rascal I am, I selected an inexpensive version, not knowing if I would like the concept.
I am here to tell you that that little gem is as handy as the pockets full of dust on my shirt. Makes such smooth thin line cuts, reaches in under joints and releases them. I am applying some thin Hard Maple molding trim pieces tonight and the ability to cut a precise angle and thin cut is just great. Had to cut previously installed molding and make it fit the new, w/o leaving a scar on the surrounding wood. Yes I have taken a gazillion pictures and will post some as it comes together.
If you are like me and procrastonated as long as I, then I urge you to try this handy tool. If the expensive saw are any better than this cheap one, then I'm investing my beans on a new one.
I wont say that it is a better concept but for certain applications it is the "Berries"