Carol Reed
In Memoriam
- Messages
- 5,533
- Location
- Coolidge, AZ
A few years ago Randy at Vega sold some treadmill motors to folks were buying them to convert their Jet mini-lathe to variable speed.
I have the parts together and am ready to make the conversion. But before I do, anybody here do this? Would you do it again? Pluses? Minus?
No luck over at WC. They wanted to tell me about PSI's rig. I already have everything I need. Or they wanted me to explain why I wanted to do this. I supposed I could be talked out of it, but only by those who had already done it and would not do it again for valid reasons.
So what say you kind folks? Anybody here do this?
I have the parts together and am ready to make the conversion. But before I do, anybody here do this? Would you do it again? Pluses? Minus?
No luck over at WC. They wanted to tell me about PSI's rig. I already have everything I need. Or they wanted me to explain why I wanted to do this. I supposed I could be talked out of it, but only by those who had already done it and would not do it again for valid reasons.
So what say you kind folks? Anybody here do this?