Handled Bowl

Gari Biasillo

Member
Messages
191
Location
Vancouver
Hi Guys,

I turned this a couple of weeks ago but only had chance to photograph and post it now. This was a challenge for our local club, which was to turn a multi axis piece. This handled bowl required four axis: One for the outside of the bowl pus start of handle, two more for the handle, all between centers. The fourth was to hollow out the bowl which was held in a jam fit chuck with the handle whirling around which required a lot of concentration as to not put your hand over the rest! That would hurt! :eek: I lamenated five pieces of walnut to make a 4 1/2" diameter blank.

Cheers,
Gari
 

Attachments

  • DSC00010.jpg
    DSC00010.jpg
    49.4 KB · Views: 34
  • DSC00009.jpg
    DSC00009.jpg
    51 KB · Views: 22
  • DSC00011.jpg
    DSC00011.jpg
    76.9 KB · Views: 16
Top