Cutting tapers...or straight

Niki Avrahami

In Memoriam
Messages
267
Location
Poland
Good day

On my last post, "Picture frame", I used some jig for the table saw that helps me to straighten one side of a board...

This "jig" is actually my "Sawboard" (circular saw guide) that I modified to use for taper and straight cutting.

I made it from the sawboard to save on jigs.....not too much space in my small garage, but, you can make it from whatever you find around...

Regards
niki


01.jpg



02.jpg



03.jpg



04.jpg



05.jpg



06.jpg



07.jpg



08.jpg



09.jpg



10.jpg



11.jpg



12.jpg



13.jpg



14.jpg



15.jpg
 
Very handy jig, Niki. Been using one similar for straight lining rough stock and making tapers for a while. One of the few permanent large jigs in my shop.
 
Top