Chuck Thoits
Member
- Messages
- 4,045
- Location
- NH
Ok so I get the PM 45 all set up and wired. I put the head stock spur center in it slides all the way in to the caller and stops. It seems to need to be about a 1/4" longer to tighten up so it wont spin. It is as if the head stock is worn out
I have checked the size it is an MT #2 the center is a jet MT#2 and the old one that I took from another PM 45 is to small also.
Has any one heard of a head stock shaft wearing out? Is there a way to shim it?
Is there a #2 spur center that is just a bit longer? How much bigger is a MT#3 and does any one know where to get one?
With out the center it is going to have to stay as a salad bar.
I have checked the size it is an MT #2 the center is a jet MT#2 and the old one that I took from another PM 45 is to small also.
Has any one heard of a head stock shaft wearing out? Is there a way to shim it?
Is there a #2 spur center that is just a bit longer? How much bigger is a MT#3 and does any one know where to get one?
With out the center it is going to have to stay as a salad bar.
Last edited: