help needed

John, the fence from my 3650 is 2 3/4" tall and 2" wide. Mine is very slightly wider at the top than the bottom...2.005" at the top vs. 1.995" at the bottom.

Hope this helps -
 
TS2400

The fench on my TS2400 measures 2.010 at the top and 2.005 at the bottom. It s top is 2.756 above the table (note the set up for the fence results in a small gap above the table, that gap is included in this measurement).

Dick
 
Richard brings up a good point...my height measurement (which was actually 2.764") was the fence only, and did not include the slight gap between the fence and the table top. I couldn't get that measurement, since my Ridgid fence has been replaced on the saw with an Incra setup. (I dug the factory fence out of the attic in the garage to get the measurements.) Also, based on Richard's measurements, it looks like there's a bit of variance in the width of these fences. Depending on your tolerances, it looks like 2" on the money (and a bit of sandpaper) will get you there.
 
Top