- Messages
- 7,986
- Location
- falcon heights, minnesota
this has been nothing but fun. tried doing a 6x6 photo, came out 5/8x1/2, solved that lil problem with the new post processor, except that the new one would not be accepted by the program. new version of the post processor. it seemed to work, but, almost half way done, it makes a bee line for about a foot down the y axis, comes back, does about an inch or so, goes to the right and left about 2 inches on the x axis, then plants the bit right up to the collet nut, prompting an emergency shutdown. so, yet another email sent off to the vectric people, with pics of the 7 pages of error messages generated, along with a pic of the end result. am i having fun, or aren't i?
Attachments
-
end result.jpg113.1 KB · Views: 20
-
error page 01.jpg89.1 KB · Views: 17
-
error page 02.jpg73.7 KB · Views: 16
-
error page 03.jpg89.6 KB · Views: 13
-
error page 04.jpg83.6 KB · Views: 13
-
error page 05.jpg83.2 KB · Views: 12
-
error page 06.jpg87.6 KB · Views: 13
-
error page 07.jpg85.9 KB · Views: 13