John Zmuda
Member
- Messages
- 2
- Location
- Lakewood , CA
Hey All,
I'm new to woodworking and I thought I'd pop in to show off my first two projects. I recently acquired a used Delta table saw and the significant other decided we needed a chalk board. I did some reading and decided that I would float the chalk board in an oak frame with a coved bottom to hold the chalk and eraser. I made a couple mistakes which turned into good lessons but all in all I think it came out acceptable.
Saw:
Chalk Board:
After receiving approval from the boss she sent me back to the garage to make picture frames. We went to Woodcraft and picked up a few goodies then off I went. Unfortunately I didn't think to photograph the process until it was near complete
Frames:
I know these projects are super easy compared to a lot of the beautiful work posted here, but it's a start. Next I want to try something with drawers.
Thanks for looking,
John
I'm new to woodworking and I thought I'd pop in to show off my first two projects. I recently acquired a used Delta table saw and the significant other decided we needed a chalk board. I did some reading and decided that I would float the chalk board in an oak frame with a coved bottom to hold the chalk and eraser. I made a couple mistakes which turned into good lessons but all in all I think it came out acceptable.
Saw:
Chalk Board:
After receiving approval from the boss she sent me back to the garage to make picture frames. We went to Woodcraft and picked up a few goodies then off I went. Unfortunately I didn't think to photograph the process until it was near complete
Frames:
I know these projects are super easy compared to a lot of the beautiful work posted here, but it's a start. Next I want to try something with drawers.
Thanks for looking,
John