Cynthia White
Member
- Messages
- 3,220
Okay, I was cruising along this morning trying to get some more shelves up in the shop with some angled supports, and while I was cutting one support, the blade in the SCMS got stuck in the wood. So I shut off the saw, unplugged it, and I had a hard time getting the wood off the blade.
So now, of course, the blade is no longer square to the fence or square to the table. My question is, is there an easy way to tell if the blade is bent altogether? (before I spend an hour doing all kinds of adjustments?)
I probably have about 100 hours on this saw (and this blade). This is my SCMS.
No sense showing you a half cut piece of 2X4.
So now, of course, the blade is no longer square to the fence or square to the table. My question is, is there an easy way to tell if the blade is bent altogether? (before I spend an hour doing all kinds of adjustments?)
I probably have about 100 hours on this saw (and this blade). This is my SCMS.
No sense showing you a half cut piece of 2X4.
Last edited: