- Messages
- 8,631
- Location
- Thomasville, GA
I got a request a couple of weeks ago asking if I could make some templates for a Mortise Pal. Never having heard of it, I looked it up and said, "Sure I can." The templates that came with the jig are in 1/2" increments and the VIP needs some in 1/4" increments.
I set up a basic drawing in VCarve while awaiting a sample template from the VIP. A few tweaks to my drawing after going over the sample with my dial caliper, then running a test followed by a couple more tweaks and this is what I produced. Each template measures 5.75" long by 1.4375" wide and is cut from 0.118" polycarbonate (Lexan).
If anyone else needs some of these, let me know via PM.
I set up a basic drawing in VCarve while awaiting a sample template from the VIP. A few tweaks to my drawing after going over the sample with my dial caliper, then running a test followed by a couple more tweaks and this is what I produced. Each template measures 5.75" long by 1.4375" wide and is cut from 0.118" polycarbonate (Lexan).
If anyone else needs some of these, let me know via PM.