Kevin Brown
Member
- Messages
- 111
- Location
- Monroeville, IN(Fort Wayne)
OK I know there are 1000's of post all over the internet about plumbing your air supply, with a good 95% of them asking what kind of pipe to use, but I've already decided on 3/4" black pipe!
My question is when, where, and how often to filter, regulate, and dry all of this air.
I have a IR 2stage 175psi 24cfm air compressor,and planning on about 175-200ft of pipe, and 5 or 6 drops for now. With one of those for a MIG and one for the finish room, so those two would have to be really clean and dry!
Also any suggestions on brands and or suppliers for filters, regulators, and dryers? I know Norgren, and Motorguard have been recommended in the past, but would like a good place to get them.
My question is when, where, and how often to filter, regulate, and dry all of this air.
I have a IR 2stage 175psi 24cfm air compressor,and planning on about 175-200ft of pipe, and 5 or 6 drops for now. With one of those for a MIG and one for the finish room, so those two would have to be really clean and dry!
Also any suggestions on brands and or suppliers for filters, regulators, and dryers? I know Norgren, and Motorguard have been recommended in the past, but would like a good place to get them.