Kevin Sadaj
Member
- Messages
- 144
- Location
- Michigan
I have finished the carbass of my workbench. It is the first workbench I have built. It is so long and has so many dividers, the drawer holes came out not square. If i took it apart, i would probably ruin it since the glue is already set.
I'm using 3/4 standard drawer slides. They are 22" deep and some are off up to 1/2".
My question: is there a method I could use to install my drawers, like with shims or something?
Or should I just consider installing shelves, putting a door on it and calling it a day?
I'm using 3/4 standard drawer slides. They are 22" deep and some are off up to 1/2".
My question: is there a method I could use to install my drawers, like with shims or something?
Or should I just consider installing shelves, putting a door on it and calling it a day?